Operating Instructions - Skil DL527502 Guide D'utilisation

OPERATING INSTRUCTIONS

WARNING
allow a fluid to flow inside them. Corrosive or conductive fluids, such as seawater, certain
industrial chemicals, and bleach or bleach-containing products, etc., can cause a short circuit.
WARNING
missing parts could result in serious personal injury.
WARNING
or modification is misuse and could result in a hazardous condition leading to possible serious
injury.
This cordless spot light must be used only with the battery packs and charger listed
below:
2Ah
SKIL BY519701
NOTICE: Please refer to the battery and
charger manuals for detailed operating
information.
To Attach/Detach Battery Pack
(Fig.2)
a. To attach the battery pack:
Align the raised rib on the battery pack with
the grooves on the tool, and then slide the
battery pack onto the tool.
b. To detach the battery pack:
Depress the battery-release button, located
on the front of the battery pack, to release
the battery pack. Pull the battery pack out
and remove it from the tool.
NOTICE: When placing the battery pack on the tool, be sure that the raised rib on the battery
pack aligns with the groove in the tool and that the latches snap into place properly. Improper
attachment of the battery pack can cause damage to internal components.
10
To reduce the risk of fire, personal injury, and product damage due to
a short circuit, never immerse your tool or battery pack in fluid or
If any parts are damaged or missing, do not operate this product
until the parts are replaced.
Do not attempt to modify this tool or create accessories
not recommended for use with this tool.
Battery Pack
4Ah
SKIL BY519601
Use of this product with damaged or
5Ah
SKIL BY519603
Fig. 2
Attach
Battery-Release
Button
Any such alteration
Charger
SKIL SC535801
Detach