Technical Specifications - Viessmann Sh0 Mode D'emploi

Masquer les pouces

Table des Matières

Les langues disponibles

load drawn from the digital system. This trans-

former may not be used as the power supply

for the digital command station or a booster!

The integral contact (wired to the two red cables) of

the semaphore distant signal can be used to switch

the track and thus for automatic train control.

Programming of the address

Every digital device requires an address in order

to allow the command control station or any other

input device to send specifi c commands. The

desired address has to be programmed. In order

to do this, connect the signal to the digital system

temporarily. Now you have to switch the decoder

into programming mode. Push a ball point pen into

the small opening of the signal drive.

If you push once the decoder is ready for program-

ming in the Märklin-/Motorola format: The signal

slowly changes its aspect three times as confi rma-

tion.

A second push with the pen and the decoder

is ready for the NMRA-DCC format. The signal

changes ist aspect three times – this time very

rapidly.

Enter the desired address and switch the signal.

Now the signal has been programmed and con-

fi rms this by slowly changing its aspect three times.

If you use the pen a third time, without sending a

switching command beforehand, the signal returns

to normal operating mode. The address is not

changed.

In the NMRA-DCC mode the signal can also be

programmed to a locomotive address which can

then be activated by pushing one of the function

buttons 'F1' – 'F4'. This may be used with the

Roco Lokmaus 2. To avoid any unwanted side

effects it is important to switch off the command

station prior to programming. Otherwise the digital

signal would respond to the fi rst command for a

locomotive with active 'F' button and would be

programmed to this particular address.