Safety Guidelines; Other Instructions - VINCENT SV-226MKII Manuel D'utilisation

SAFETY GUIDELINES

This appliance was produced under strict quality controls.
It complies with all established international safety standards.
Nonetheless, the following instructions should be fully read and
observed in order to prevent any hazard:
Do not open the appliance! Risk of electric shock!
There are no parts in the appliance that require maintenance by the user.
Maintenance/Alterations
All equipment that is connected to the domestic
mains voltage can be dangerous to the user if not
handled properly. Leave maintenance work to
qualified professionals. The product is only per-
mitted for connection to AC 230Volt/50Hz, for
earthed sockets and use in enclosed areas.
Altering the product or manipulating its serial num-
ber voids the warranty. After a fault, leave the
appliance's fuse to be replaced only by a profes-
sional with one of the same kind.
Power Cable Connection
Always pull the plug and never the power cable if
you want to disconnect the appliance from the
mains power. Make sure when setting up the
appliance that the power cable is not squashed,
severely bent or damaged by sharp edges.
Do not touch the power lead with wet or damp
hands. Use the power cable supplied or another
one from Vincent.
Switching Off
Switch the appliance off every time before you
connect or remove other components or loudspea-
kers, disconnect or connect it to the mains power,
leave it unused for a longer period or want to
clean its outside. On all amplifiers and receivers,
wait approx. 1 minute after this before disconnec-
ting or reconnecting the cable.
Moisture/Heat/Vibration
Contact of electrically operated equipment with
liquids, moisture, rain or water vapour is dange-
rous for such equipment and the user and must be
24 Vincent
avoided without fail. Take care that no liquids or
objects get inside the appliance (ventilation slots
etc.). It must be disconnected from the mains power
immediately and examined by a professional if
this happens. Never expose the appliance to high
temperatures (direct sunshine) or strong vibration.
Heat Build-up
All amplifiers generate heat as part of their
design. Make sure that a gap of 5 cm remains
around the appliance and that the surrounding air
can circulate (do not install in enclosed cupbo-
ards). Vents must not be covered up.
Volume
The maximum tolerable volume is always reached
well below the maximum possible setting on the
amplifier. Be careful with the volume setting, there-
fore, in order to prevent damage to hearing. So that
you do not expose yourself to high volumes uninten-
ON
tionally, always set to a low level before changing
the input channel.
OFF
Cleaning
Pull out the plug before cleaning the outside of the
product. Whenever possible, use a soft, lint-free
cloth that has been dampened. Do not use abrasi-
ves, solvents, thinners, flammable chemicals, polis-
hes and other cleaning products that leave marks.
Batteries
Take note of the instructions for using batteries in
the chapter "Remote Control".

OTHER INSTRUCTIONS

Setting up the appliance
How the system is set up has an effect on the
sound quality. Therefore only place it on a suitab-
le, stable surface. To make the most of your
system's sound quality, we recommend placing the
equipment on Vincent racks and not putting them
on top of each other.
Old electronic equipment
This appliance is subject to the conditions set out
in the European Directive 2002/96/EC. This is
identified by the symbol of a crossed out waste bin
on the appliance.
What this means for you as a consumer: All old
electrical and electronic equipment that is no lon-
ger used must be disposed of separately from
domestic waste using places provided by the aut-
horities. By doing so you can prevent damage to
the environment and help to encourage manufac-
turers to produce more durable or reusable pro-
ducts. For further information about disposing
your old appliance, please consult your local aut-
hority, waste disposal agency or the shop where
you bought the product.
CE sign
This appliance complies with the current EU direc-
tives about attaining the CE mark and thus meets
the requirements for electrical and electronic
equipment (EMC regulations, regulations and
regulations for low voltage equipment).
Declarations
This document was written by Andreas Böer. It is
a product of Sintron Vertriebs GmbH, 76473
Iffezheim and may not be copied or distributed
partly or in full without express, written consent.
Vincent is a registered trademark of Sintron Vertriebs
GmbH, 76473 Iffezheim.
Vincent is a registered trademark of Sintron Vertriebs
GmbH, 76473 Iffezheim.
Vincent works continually to improve and develop
its products. Therefore, the appearance and techni-
cal design of the appliance are subject to changes,
as long as they are in the interest of progress.
The content of these instructions is for information
purposes only. It can be changed at any time wit-
hout prior notice and does not constitute any obli-
gation on the part of the trademark's owner. The
latter assumes no responsibility or liability for
errors or inaccuracies, which may be included in
these operating instructions.
Storage of the packaging
We strongly recommend that you keep the original
packaging in case you need to transport the equip-
ment again at a later date. Transport damages are
mainly caused by improper packaging of the HiFi-
devices. Because the original packaging fits the
equipment accurately it will reduce the risk of
damage if transport is necessary.
Explanation of the symbols
The lightening bolt tells you that dange-
rous voltages are present in the applian-
ce, which can cause an electric shock.
This symbol brings your attention to par-
ticularly important information regarding
operation and maintenance.
This symbol identifies useful information
and advice about how to handle the
appliance.
This manual is valid for all appliances
SV-226MKII that have been produced after
the devices with the serial numbers
V1506S001S-060S (silver) and
V1506S001B-050B (black).
Vincent 25