JVC AV-32WFT1EP Manuel D'instructions page 17

                                       
To display the PICTURE FEATURES menu:
1
Press the
(main menu).
2
Press the
FEATURES, and press the
   



          
The AUTO VNR function optimally reduces noise of the TV
automatically according to the noise of the current picture.
The function also adjusts the optimum Sharpness (SHARP).
1
Press the
VNR.

2
Press the
MIN:
The AUTO VNR function is cancelled. When you set the
mode to AUTO but feel that the sharpness of the original
picture has not be reproduced fully, change the mode to
MIN. However, a noise remaining in the original picture
may be emphasized.
MAX:
This mode always maximizes the noise reduction effect
irrespective of state of the picture. When you set the
mode to AUTO but feel that the noise is remarkable,
change the mode to MAX. However, this may reduce the
sharpness of the picture.


3
Press the
ting.
The menu disappears.
                               



       
The colour system is chosen automatically. However, if the
picture is not clear or no colour appears, choose the colour
system manually.


1
Press the
SYSTEM. Then press the
The Sub-menu of the COLOUR SYSTEM function ap-
pears.




button to display MENU


button to choose PICTURE


button.


buttons to choose AUTO
buttons to choose AUTO.
button to complete the set-
buttons to choose COLOUR


button.

2
Press the buttons to choose the ap-
propriate colour system.
PAL:
PAL system
SECAM:
SECAM system
NTSC 3.58:
NTSC 3.58 MHz system
NTSC 4.43
NTSC 4.43 MHz system
AUTO:
This function detects a colour system from the input sig-
nal. Only when you are viewing a picture from Pro-
gramme number PR 0 (AV), or EXT terminal, you can
choose using the AUTO function.


3
Press the button to complete the set-
ting.
The menu disappears.
Note:
• The AUTO function may not function properly if you
have poor signal quality. If the picture is abnormal in
the AUTO function, choose another colour system
manually.
• When in the Programme numbers PR 0 (AV) to PR
99, you cannot choose NTSC 3.58 or NTSC 4.43.
   



                   




You can choose one of three ZOOM modes, REGULAR,
PANORAMIC or 14:9 ZOOM, as the ZOOM mode for the nor-
mal picture (4:3 aspect ratio).


1
Press the buttons to choose 4:3 AUTO
ASPECT. Then press the
The Sub-menu of the 4:3 AUTO ASPECT function ap-
pears.


2
Press the buttons to choose a ZOOM
mode.


3
Press the button to complete the set-
tings.
The menu disappears.


button.