Care And Maintenance - Medisana MTC Mode D'emploi

51139_MTC_West_aktual.qxd:Blutdruckmessgerät
GB
6 Miscellaneous
6.2
Care and
maintenance
6.3
Disposal
6.4
Directives /
Norms
22
• Remove the batteries before cleaning the unit.
• Never use strong detergents or hard brushes.
• Clean the unit using a soft cloth lightly moistened with a mild soapy
solution. Never use abrasive cleaning agents or alcohol.
• Do not allow any water to get into the unit. Do not use the unit again until
it is completely dry.
• Remove the batteries from the unit if you do not wish to use it for an
extended period of time, otherwise there is a risk of battery leakage.
• Do not expose the unit to direct sunlight, and protect it from dust and
moisture.
• Only inflate the cuff when it is in position around the upper arm.
• The unit is best kept in the storage pouch included in your purchase and
should preferably be stored in a clean dry place.
• Servicing and calibration (applies to commercial use):
The unit has been calibrated by the manufacturer for a period of two years'
use. In the case of commercial use, the unit must be serviced and recali-
brated at least once every two years. This calibration will be charged for and
can be carried out by an appropriate authority or an authorised service
centre - in accordance with the regulations for users of medical equipment.
This product must not be disposed of with domestic waste.
All users are obliged to hand in all electrical or electronic devices, regardless
of whether or not they contain toxic substances, at a municipal or commer-
cial collection point so that they can be disposed of in an environmentally
acceptable manner.
Please remove the batteries before disposing of the device / unit. Do not dis-
pose of old batteries with your household waste, but at a battery collection
station at a recycling site or in a shop.
Consult your municipal authority or your dealer for information about disposal.
This blood pressure monitor meets the requirements of the EU standard for
non-invasive blood pressure monitors. It is certified in accordance with EC
Guidelines and carries the CE symbol (conformity symbol) "CE 0297".
The blood pressure monitor corresponds to European standards EN 60601-1,
EN 60601-1-2, EN 1060, EN 14971 and EN 980.
The specifications of EU Guideline "93/42/EEC of the Council Directive dated
14 June 1993 concerning medical devices" are met.
Electromagnetic compatibility:
The device complies with the EN 60601-1-2 standard for electromagnetic
compatibility.
Inquire at MEDISANA for details on this measurement data.
Intended use:
This unit is suitable for non-invasive blood pressure measurement in adults
(i.e., suitable for external use).
07.12.2010 12:03 Uhr Seite 22