Replacing The Batteries - Hitachi WH 12DM2 Instructions De Sécurité Et Mode D'emploi

English
(2) The direction of the light can be adjusted within
the range of hook positions 1 – 5. (Fig. 9)
Lighting time
AAAA manganese batteries: approx. 15
hrs.
AAAA alkali batteries: approx. 30 hrs.
CAUTION:
●
Do not look directly into the light.
Such actions could result in eye injury.

1.3 Replacing the batteries

(1) Loosen the hook screw with a Phillips-head
screwdriver (No. 1). (Fig. 10)
Remove the hook cover by pushing in the
direction of the arrow. (Fig. 11)
(2) Remove the old batteries and insert the new
batteries. Align with the hook indications and
position the plus (+) and minus (–) terminals
correctly. (Fig. 12)
(3) Align the indentation in the hook main body
with the protuberance of the hook cover, press
the hook cover in the direction opposite to that
of the arrow shown in Fig. 11 and then tighten
the screw.
Use commercially available AAAA batteries
(1.5 V).
NOTE: Do not tighten the screw excessively. Such
action could strip the screw threads.
CAUTION:
●
Failure to observe the following can result in
battery leakage, rust or malfunction.
Position the plus (+) and minus (–) terminals
correctly.
Replace both batteries at the same time. Do
not mix old and new batteries.
Remove exhausted batteries from the hook
immediately.
●
Do not discard batteries together with normal
trash and do not throw batteries into fire.
●
Store batteries out of the reach of children.
●
Use batteries correctly in accordance with the
battery specifications and indications.
18
3
2
1
Screw
Hook
Fig. 10
Fig. 11
Hook main body
+ –
Inden-
tation
AAAA
batteries
– +
Indentation
Fig. 12
5
4
Switch
Hook
Fig. 9
Phillips-head
screwdriver
Arrow
Hook cover
Protube-
rance
Protube-
rance
Hook cover