Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The light equipped hook has the following two functions:
It can be used as a hook for suspending from a waist belt when required by the
nature of the work.
It can be used as an auxiliary light for such operations as tightening screws in a
dark place.
1.1 Using the hook
The hook can be installed on the right or left side
and the angle can be adjusted in 5 steps between
0° and 80°.
(1) Operating the hook
(a) Pull out the hook toward you in the direction
of arrow (A) and turn in the direction of arrow
(B). (Fig. 5)
(b) The angle can be adjusted in 5 steps (0°, 20°,
40°, 60°, 80°).
Adjust the angle of the hook to the desired
position for use.
(2) Switching the hook position
CAUTION:
●
If the tool falls, there is a risk that malfunction and/
or physical damage can occur. It is recommended
that you also use fall-preventing wires, etc.
●
Incomplete installation of the hook may result in
bodily injury when used.
(a) Securely hold the main unit and remove the
screw using a slotted head screwdriver or a
coin. (Fig. 6)
(b) Remove the hook and spring. (Fig. 7)
(c) Install the hook and spring on the other side
and securely fasten with screw. (Fig. 6)
NOTE: Pay attention to the spring orientation.
Install the spring with larger diameter away
from you. (Fig. 8)
1.2 Using as an auxiliary light
(1) Press the switch to turn off the light.
If forgotten, the light will turn off automatically
after 15 minutes.
5
4
3
(B)
2
1
Fig. 5
Loosen
Fig. 6
Spring
Fig. 7
Larger diameter faces away
Fig. 8
English
Hook
(A)
17
Publicité
Table des Matières
