Replacing The Batteries - Hitachi WH 18DFL Instructions De Sécurité Et Mode D'emploi

English
(c) Install the hook and spring on the other side
and securely fasten with screw. (Fig. 6)
NOTE:
Pay attention to the spring orientation. Install the
spring with larger diameter away from you (Fig. 8).
Larger
diameter
1.2 Using as an auxiliary light
(1) Press the switch to turn off the light.
If forgotten, the light will turn off automatically after
15 minutes.
(2) The direction of the light can be adjusted within
the range of hook positions 1 - 5. (Fig. 9)
2
1
Lighting time
AAAA manganese batteries: approx. 15 hrs.
AAAA alkali batteries: approx. 30 hrs.
CAUTION:
Do not look directly into the light.
Such actions could result in eye injury.

1.3 Replacing the batteries

(1) Loosen the hook screw with a phillips-head
screwdriver (No. 1). (Fig. 10)
Hook
Screw
Phillips - head screwdriver
14
Fig. 8
5
4
3
Switch
Hook
Fig. 9
Fig. 10
Remove the hook cover by pushing in the direction
of the arrow. (Fig. 11)
(2) Remove the old batteries and insert the new
batteries. Align with the hook indications and
position the plus (+) and minus (-) terminals
correctly. (Fig. 12)
Hook main body
Indentation
AAAA
batteries
Indentation
(3) Align the indentation in the hook main body with
the protuberance of the hook cover, press the hook
cover in the direction opposite to that of the arrow
shown in Fig. 11 and then tighten the screw.
Use commercially available AAAA batteries
(1.5 V).
NOTE:
Do not tighten the screw excessively. Such action
could strip the screw threads.
CAUTION:
●
Failure to observe the following can result in
battery leakage, rust or malfunction.
Position the plus (+) and minus (-) terminals
correctly.
Replace both batteries at the same time. Do not
mix old and new batteries.
Remove exhausted batteries from the hook
immediately.
●
Do not discard batteries together with normal
trash and do not throw batteries into fire.
●
Store batteries out of the reach of children.
●
Use batteries correctly in accordance with the
battery specifications and indications.
2. Installing the bit
Always follow the following procedure to install
driver bit. (Fig. 13)
Arrow
Hook cover
Fig. 11
Protuberance
Protuberance
Hook cover
Fig. 12