Elite Super Crono Notice D'utilisation page 30

GB
Attention: It is possible to execute the erasing
procedure only at zero speed. During this
operation we suggest you detach the cable on
the rear side of the computer.
Press the SET button. For the first three seconds
the screen doesn't change.
By pressing the SET button, after the first three
seconds, the ClEAR message will appear,
showing that you're about to erase the data - it is
possible to interrupt the erasing of the data sim-
ply by stopping pressing the button.
After having pressed the SET button for six
seconds a screen with ClEAR & dONE showing
will appear. This means that the erasing of data
has been done. Now you can stop pressing the
button.
Hereafter you will see the screens that will appe-
ar during the procedure.
SYNCHRONISATION
The synchronisation procedure allows the tran-
smission of data to be coded in such a way that
only the correct information, relevant to training,
is displayed on the computer (even in the presen-
ce of several people using different SuperCrono
Wireless units or the presence of interference on
the same frequency).
Synchronization procedure:
1. Remove the resistance unit from the base.
2. Remove the cap closing the tube protruding
from the bottom by about 1 cm. Inside this tube
there is a button.
3. Turn off the computer (for the version with
switch, place it on "off"; for the version without
switch, wait for 2 minutes).
4. Turn on the computer (for the version with
switch, place it on "on"; for the version without
30
switch, push one of the 2 digits).
5. Press the button present on the transmission
unit twice within 15 seconds after the computer is
switched on. If you cannot reach the button with
your fingers, use a pencil or something similar.
6. If the procedure is has been carried out correct-
ly, a speed of 99.9 Km/h appears on the screen for
one second.
Now the computer will only receive data from the
resistance unit to which its has been linked.
This link will always remain even when the batte-
ries are changed.
bATTERIEs
The Supercrono Wireless computer uses two AA
type batteries.
To optimize power consumption during the
standby phase it is recommended to detach the
computer cable from the support.
In the best conditions, normal alkaline batteries
should last about 200 hours. It is not possible to
use rechargeable batteries that are not 1,5 Volt.
The radio transmitter placed in the resistance unit
also uses two AA type batteries. The electric
circuit that controls this part consume power only
when the roller is turning. So there's no need to
turn off the transmitter.