GreenWorks Tools 9000007 Manuel D'utilisation page 8

If the prop nut is overtightened it may cause damage
to the prop or cause too much pressure/strain on the
motor which may cause overheating or premature
battery drain.
MAINTENANCE
■ The propeller must be cleaned of weeds and fishing
line. Line can get behind the prop, wear away the
seals and allow water to enter the motor. Disconnect
battery and check this after each use.
■ To prevent accidental damage during trailering or
storage, disconnect the battery whenever the motor is
out of the water. For prolonged storage, lightly coat
all metal parts with silicone or lithium based lubricant
spray.
■ For maximum performance, restore battery to full
charge before each use.
■ To maintain optimum performance of the propeller
it is required to keep the leading edges of the prop
blades smooth. If there are nicks or rough edges it
is suggested to correct by using a smooth file or fine
sandpaper.
NOTE: Replace propeller if unable to repair.
English (Original Instructions)
IMPORTANT
TROUBLESHOOTING
Problem
Check battery terminal connections
MOTOR DOES
Check battery voltage or battery
NOT RUN
health/amperes to ensure of correct
OR LACKS
working levels (this may need to be
POWER
done by a technician with a correct
voltage meter)
Loosen the steering tension knob on
MOTOR
the bracket
TILLER IS
HARD TO
Check to ensure no debris or other
STEER
foreign materials may be constricting
movement
If these solutions do not solve the problem contact your
authorised service dealer.
8
Solution