GreenWorks Tools 9000007 Manuel D'utilisation page 6

Your product has been engineered and manufactured to
Greenworks tools' high standard for dependability, ease of
operation, and operator safety. When properly cared for,
it will give you years of rugged, trouble-free performance.
Thank you for buying a Greenworks tools product.
Save this manual for future reference
Read these instructions carefully, be familiar with the
controls and the proper use of the machine.
Please keep the instructions safe for later use!
DESCRIPTION
See figure 1.
1. Tiller speed control (Controls Speed, forward, reverse
and steering direction)
2. Shaft depth adjustment collar
3. Prop shaft tilt release lever
4. Clamping knobs
5. Boat mounting bracket
6. Adjustable shaft
7. Propeller
8. 12V DC Motor
9. Weedless propeller
10. Slot end
11. Prop nut
12. Washer
13. Drive pin
SPECIFICATIONS
Trolling motor
Motor
Thrust
Prop speeds
Forward speed
Reverse speed
ASSEMBLY
MOUNTING THE MOTOR
See figure 2.
Install the motor on the transom of the boat. Be sure to
tighten the clamp knob (4) by turning clockwise securely.
To loosen the clamp knob (4) by turning counterclockwise.
English (Original Instructions)
WARNING
9000007
12 V
32 lbs
1400-1650 RPM
5 speeds
3 speeds
DEPTH ADJUSTMENT
■ Firmly grasp the shaft and hold it steady.
■ Loosen the steering tension knob (3) and depth collar
knob (2) until the tube slides freely.
■ Raise or lower the motor (8) to the desired depth.
■ Tighten depth collar knob (2) to secure the motor in
place.
WHEN SETTING THE DEPTH BE SURE THE TOP OF
THE MOTOR IS SUBMERGED AT LEAST 12" (30 cm)
TO AVOID CHURNING OR AGITATION OF SURFACE
WATER. THE PROPELLER MUST BE COMPLETELY
SUBMERGED.
• NEVER OPERATE YOUR MOTOR WHEN IT IS OUT
OF THE WATER.
• OVER-TIGHTENING THE CLAMP SCREWS CAN
DAMAGE THE BRACKET.
BRACKET ADJUSTMENT
See figure 3.
You can lock your motor in a vertical position, angle it for
shallow water or tilt it completely out of the water.
■ Firmly grasp the control head or shaft.
■ Depress and hold the tilt lever (3).
■ Tilt to any of the positions on the mounting bracket.
■ Release the tilt lever (3).
WHEN MAKING ANY ADJUSTMENTS TO MOTOR
OR PROPELLER
DISCONNECTED FROM THE TROLLING MOTOR
WIRE LEADS.
OPERATION
TILT TWIST TILLER
See figure 4.
These motors offer a choice of five forward and three
reverse speeds. The speed control may be operated in
either direction, forward or reverse.
6
IMPORTANT
CAUTION
WARNING
THE BATTERY MUST BE