Battery Connection; Propeller Replacement - GreenWorks Tools 9000007 Manuel D'utilisation

■ Turn the tilt twist tiller handle (1) counterclockwise
from O (off) to increase reverse speed.
■ Turn the tilt twist tiller handle (1) clockwise from O (off)
to increase forward speed.
Thrust decreases as you approach O from either direction.
BATTERY
12 V BATTERY INFORMATION
NOTE: Battery sold seperately.
The motors will operate with any deep cycle marine 12
V battery.
For best results it is recommended to use a deep cycle
marine battery with a minimum of 105 ampere hour rating.
As a general on the water estimate, your 12 V motor
will draw one ampere per hour for each pound of thrust
produced when the motor is running on high. The actual
ampere draw is subject to your particular environmental
conditions and operation requirements.
Always store battery at full charge when not in use. Battery
life will be extended by charging each time battery is used
and every two weeks when not in use. (Use a lamp timer
and charge each day for 1 hour even if battery is not use
as this will help maintain a full battery level.)
NOTE: Only trickle charge your battery to full power, do
not speed/rapid charge the battery as this will shorten its
life.
If you are using a crank battery to start a gasoline outboard
it is strongly recommended to use a separate battery for
trolling motor to ensure of enough start up power for the
gasoline motor.

BATTERY CONNECTION

12 V Systems
■ Connect the positive (+) red lead to the positive (+)
battery terminal.
■ Connect the negative (-) blace lead to the negative (-)
battery terminal.
NOTE: If installing a leadwire plug, observe proper polarity
and follow instructions in your boat owner's manual.
English (Original Instructions)
7
• BEFORE CONNECTING BATTERY, MAKE SURE
THE TWIST TILLER HANDLE IS IN THE OFF
POSITION.
• USE 6 GAUGE WIRE TO EXTEND POWER LEAD.
• KEEP LEADWIRE CONNECTION TIGHT AND SOLID
TO BATTERY TERMINALS.
• LOCATE BATTERY
COMPARTMENT.
This is supplied as a quick reference guide however
battery types, brands and sizes may vary in performance
and abilities. Always read your battery manufacturers
manual for specific battery requirements or contact the
manufacturer for best practices and/or advice.

PROPELLER REPLACEMENT

DISCONNECT THE MOTOR FROM THE BATTERY
BEFORE BEGINNING ANY PROP WORK OR
MAINTENANCE.
PROPELLER REPLACEMENT
See figure 5.
■ Using a cloth or glove, hold the propeller (9) and
loosen the prop nut (11) with a (1/2", 12.7mm) socket.
■ Remove the prop nut (11) and washer.
NOTE: If the drive pin has been damaged or broken you
will need to use a standard/slotted screwdriver to hold the
shaft still. The prop shaft has a slot in the center in case
of this issue.
■ Once the nut and washer are removed pull the prop
straight off.
■ The drive pin is located behind the prop, ensure it has
not fallen out and if it has reinstall in position before
reinstalling the prop.
■ When reinstalling the prop tighten the prop nut (11) 1/4
turn past snug (25 - 35 in lbs.)
WARNING
IN A VENTILATED
IMPORTANT
WARNING