RIDGID R4210 Manuel D'utilisation page 17

ASSEMBLY
DEPTH CONTROL
KNOB
LOCK
NUT
DEPTH
STOP
 Rotate the depth stop inward for normal through cuts.
NOTE: The depth stop must be pushed in before locking/
unlocking the saw arm.
LOCKING/UNLOCKING THE SAW ARM
See Figure 12.
When locking and unlocking the saw arm, it is not necessary
to loosen the depth control knob, however the depth stop
must be pushed in.
To unlock and raise the saw arm:
 Firmly grasp the "D" handle and apply downward pres-
sure while at the same time pulling the head lock pin out
and away from the saw housing.
 Release the head lock pin and slowly raise the saw arm.
To lock the saw arm:
 Firmly grasp the "D" handle and apply downward pres-
sure until head stops. Push in the head lock pin toward
the saw.
 Release the head lock pin allowing it to lock the saw into
place.
NOTE: Do not use saw to cut while in the locked position.
DUST BAG AND FRAME ASSEMBLY
See Figure 13.
To install the dust bag and frame assembly, slide the open
end of the frame assembly onto the exhaust port.
For efficient operation, empty the dust bag before it is half
full. This will permit better air flow through the bag.
NOTE: The exhaust port also accepts a 1-1/4 in. vacuum
hose and 1-1/4 in. wet/dry vacuum adaptors.
HEAD LOCK
PIN
D HANDLE
Fig. 11
DUST
17 - English
END OF FRAME
BAG
ASSEMBLY
HEAD LOCK
PIN
Fig. 12
EXHAUST
PORT
Fig. 13