RIDGID R4210 Manuel D'utilisation page 5

ADDITIONAL SAFETY RULES
 Never stand or have any part of the body in line with the
path of the saw blade.
 Do not turn the motor switch on and off rapidly. This
could cause the saw blade to loosen and could create a
hazard. Should this ever occur, stand clear and allow the
saw blade to come to a complete stop. Disconnect your
saw from the power supply and securely retighten the
blade bolt.
 If any part of this miter saw is missing or should break,
bend, or fail in any way, or should any electrical component
fail to perform properly, shut off the power switch, remove
the miter saw plug from the power source and have
damaged, missing, or failed parts replaced before resuming
operation.
 Always turn off the saw before disconnecting it to avoid
accidental starting when reconnecting to power supply.
NEVER leave the saw unattended while connected to a
power source.
 This tool should have the following markings:
• To reduce the risk of injury, user must read and under-
stand the operator's manual before using the miter saw.
• Keep hands and body out of the path of the saw blade.
Contact with the blade will result in serious injury.
• Do not operate saw without guards in place.
• Check guarding system to make sure it is functioning
correctly.
• Do not perform any operation freehand.
• Never reach around the saw blade.
• Turn off tool and wait for saw blade to stop before rais-
ing saw arm, moving workpiece, or changing settings.
• Disconnect the saw from the power source before
changing blade or servicing.
 Always carry the tool only by the carrying handle.
 This saw can tip over if the saw head is released suddenly
and the saw is not secured to a work surface. Always
secure this saw to a stable work surface before any use
to avoid serious personal injury.
 Always make sure the saw blade has clearance of
all obstructions before turning the saw on.
5 - English