Technical Characteristics - PRESIDENT Andy ASC AM/FM 12 V Manuel D'utilisation

1) TALKBACK
(PTT + F)
The TALKBACK function can be activated or deactivated as follows:
a) Press and hold the PTT switch (8)
b) Short press on F key (5). Current TALKBACK level blinks 3 times al-
lowing you to adjust this level.
When function is activated, "TALKBACK" appears on the display.
This function allows to ear your own modulation with the CB speaker.
2) TALKBACK LEVEL
(PTT + s/t on the unit)
- At step b) adjust the TALKBACK level using the s/t keys on the
unit.
- When the function in on and "TALKBACK" is shown on the display,
press and hold the PTT switch (8), then use the s/t keys on the
unit. 9 levels from 01 to 09.
- Note: The use of the UP/DN knobs (2) on microphone are not allowed
to adjust TALKBACK level.
3) PA
(PTT + MODE)
- Press and hold the PTT switch (8)
- Short press on MODE key (6) to activated or deactivated the PA
(Public Address) mode. An external loud speaker can be connected
to your ANDY ASC AM/FM by the PA jack plug situated on the back
panel PA.SP (D). The CB message received or transmitted into the
microphone will be directed towards the external speaker and be
amplified. Adjust the PA volume with VOL key (1).
When PA mode is activated, "PA" and the used mode (AM, FM
or FM UK) blink alternatively. When PTT switch (8) is pressed, "PA"
replace the active channel on the display. Release the PTT switch
(8) to display again the active channel.
A) DC-POWER TERMINAL (13,2 V / 26,4 V)
B) ANTENNA CONNECTOR (SO-239)
C) EXTERNAL SPEAKER JACK (8 Ω, Ø 3,5 mm)
D) PA SPEAKER JACK (8 Ω, Ø 3,5 mm)
E) TECHNICAL CHARACTERISTICS
1) GENERAL
- Channels
- Modulation modes
- Frequency ranges
- Antenna impedance
- Power supply
- Dimensions (in mm)
- Weight
- Accessories supplied
- Filter
2) TRANSMISSION
- Frequency allowance
- Carrier power
- Transmission interference
- Audio response
- Emitted power in the adj.
channel
- Microphone sensitivity
- Maximum drain
- Modul. signal distortion
3) RECEPTION
- Maxi. sensitivity at 20
dB sinad
- Frequency response
- Adjacent chan. selectivity : 60 dB
- Maximum audio power
- Squelch sensitivity
- Frequency image
rejection rate
- Intermediate frequency
rejection rate
- Drain
33
: 40
: AM/FM
: from 26.965 MHz to 27.405 MHz
: 50 ohms
: 13.2 V / 26.4 V
: 125 (L) x 175 (H) x 45 (D)
: ~ 0.9 kg
: Electret microphone with support,
mounting cradle, screws.
: ANL (Automatic Noise Limiter) built-in
: +/- 200 Hz
: 4 W AM / 4 W FM
: inferior to 4 nW (- 54 dBm)
: 300 Hz to 3 KHz in AM/FM
: inferior to 20 µW
: 7 mV
: 1.7 A at 13.2 V / 0.85 A at 26.4 V
: 2 %
: 0.5 µV - 113 dBm AM / 0.35 µV - 116 dBm FM
: 300 Hz to 3 kHz
: 2.5 W
: minimum 0.2 µV - 120 dBm
maximum 1 mV - 47 dBm
: 60 dB
: 70 dB
: 180 ~ 500 mA (13.2 V)
100 ~ 300 mA (24.6 V)