PRESIDENT Andy ASC AM/FM 12 V Manuel D'utilisation page 31

4) DISPLAY
It shows all functions:
The BARGRAPH shows the reception level and the output power
level.
5) EMG ~ EMG SETTING
EMG
(short press)
Emergency channel is automatically selected when you press EMG
Key (5). "EMG" is displayed.
The default emergency channel is channel 19 and the mode (AM/
FM) is set according the frequency range in use (see table page
53).
New short press in EMG key (5) to go back to the current channel.
"EMG" disappears.
EMG SETTING
(long press)
Emergency channel can be set to any channel with mode AM or
FM. To set a new emergency channel:
- Short press on EMG key (5) to call the current emergency channel.
"EMG" appears on the display.
- Long press on EMG key (5).
blinks.
- Using the s/t keys (2) or the UP/DN knobs (9), select the new
emergency channel.
- Press MODE key (6) to select the mode (AM, FM or FM UK) used with
new emergency channel.
- Short press on EMG key (5) to validate and store the new emergency
channel. A validation beep sounds.
Note: Emergency setting is not allowed if the current emergency
channel is not the active channel.
appears on the display and "EMG"
6) MODE ~ NB
MODE
(short press)
This key allows you to select the modulation mode (AM or FM).
Your modulation mode has to correspond to the one of your cor-
respondent. Corresponding mode is displayed on the LCD.
- Amplitude Modulation / AM: communication on a field with relief
and obstacles at middle distance (the most used).
- Frequency Modulation / FM: for nearby communications on a flat
open field.
In U configuration ONLY: press MODE key (6) to alternate the fre-
quency band between ENG and CEPT. "UK" appears in the display
when the ENG band is selected. "UK" disappears from the display
when CEPT is selected (see table at page 49).
NB
(long press)
NOISE BLANKER. This filter allow the reduction of back ground noise,
and some reception interference. "NB" is displayed when NB filter
is active.
7) 6 PIN MICROPHONE PLUG
The plug is located on the front panel of the transceiver and makes
the setting of the equipment into the dashboard easier.
See cabling diagram page 52.
8) PTT (Push To Talk)
Transmission key, press to transmit a message,
release to listen to an incoming communication.
See FUNCTIONS WITH PTT SWITCH on page 32.
9) CHANNEL SELECTOR: UP/DN knobs on the microphone
These keys allow increasing or decreasing a channel. A «beep»
sounds each time the channel changes if the KEY BEEP function is
activated. See KEY BEEP function page 32.
See also § 2 page 30.
31
is displayed and