Installation - PRESIDENT ANDY USA 12 V Manuel D'utilisation

Welcome to the world of the new generation of CB radios. The
new PRESIDENT range gives you access to top performance
CB equipment. With the use of up-to-date technology, which
guarantees unprecedented quality, your PRESIDENT ANDY USA
12/24 V is a new step in personal communication and is the
surest choice for the most demanding of professional CB radio
users. To ensure that you make the most of all its capacities,
we advise you to read carefully this manual before installing
and using your PRESIDENT ANDY USA 12/24 V.
A) INSTALLATION
1) WHERE AND HOW TO MOUNT YOUR MOBILE CB RADIO
a) You should choose the most appropriate setting from a simple and
practical point of view.
b) Your CB radio should not interfere with the driver or the passengers.
c) Remember to provide for the passing and protection of different
wires (e.g. power, antenna, accessory cabling) so that they do not
in any way interfere with the driving of the vehicle.
MOUNTING DIAGRAM
d) To install your equipment, use the cradle (1) and the self-tapping
screws [2] provided (drilling diameter 3.2 mm). Take care not to
damage the vehicle's electrical system while drilling the dash board.
e) Choose where to place the microphone support and remember that
the microphone cord must stretch to the driver without interfering
with the controls of the vehicle.
f) Choose where to place the microphone support and remember that
the microphone cord must stretch to the driver without interfering
with the controls of the vehicle.
- Note: As the transceiver has a frontal microphone socket, it can be
set into the dash board. In this case, you will need to add an exter-
nal loud speaker to improve the sound quality of communications
(connector EXT.SP situated on the back panel: C). Ask your dealer
for advice on mounting your CB radio.
5