Mounting Diagram; Antenna Installation - PRESIDENT Valery Classic Manuel D'utilisation

Welcome to the world of the new generation of CB radios.
The new PRESIDENT range gives you access to top perfor-
mance CB equipment. With the use of up-to-date technology,
which guarantees unprecedented quality, your PRESIDENT
VALERY is a new step in personal communication and is the
surest choice for the most demanding of professional CB
radio users. To ensure that you make the most of all its
capacities, we advise you to read carefully this manual
before installing and using your PRESIDENT VALERY.
A) INSTALLATION:
1) WHERE AND HOW TO MOUNT YOUR MOBILE CB RADIO:
a)You should choose the most appropriate setting from a simple and practical point of
view.
b) Your CB radio should not interfere with the driver or the passengers.

MOUNTING DIAGRAM

c) Remember to provide for the passing and protection of different wires (e.g. power,
antenna, accessory cabling) so that they do not in any way interfere with the driving of
the vehicle.
d) To install your equipment, use the cradle (1) and the self-tapping screws [2] provided
(drilling diameter 3.2 mm). Take care not to damage the vehicle's electrical system while
drilling the dash board.
e) Do not forget to insert the rubber joints [3] between the CB and its support as these have
a shock-absorbing effect which permits gentle orientation and tightening of the set.
f) Choose where to place the microphone support and remember that the microphone
cord must stretch to the driver without interfering with the controls of the vehicle.
- N.B. : You will need to add an external loud speaker to improve the sound quality of
communications (connector EXT.SP situated on the back panel: D). Ask your dealer for
advice on mounting your CB radio.

2) ANTENNA INSTALLATION:

25