Operation; Electrical Requirements - Zephyr Tempest II AK7500CS Guide D'utilisation, D'entretien Et D'installation

Safety Information
To reduce risk of fire and to properly exhaust air outside, do not vent exhaust air into spaces within
walls, ceilings, attics, crawl spaces, or garages.

Operation

Always leave safety grilles and filters in place. Without these components, operating blowers could
catch onto hair, fingers and loose clothing.
The manufacturer declines all responsibility in the event of failure to observe the instructions given
here for installation, maintenance and suitable use of the product. The manufacturer further
declines all responsibility for injury due to negligence and the warranty of the unit automatically
expires due to improper maintenance.
NOTE: Please check www.zephyronline.com for revisions before doing any custom work.

Electrical Requirements

Important:
Observe all governing codes and ordinances.
It is the customer's responsibility to be aware of these below:
To contact a qualified electrical installer.
To assure that the electrical installation is adequate and in conformance with National Electrical
Code, ANSI/NFPA 70 latest edition* or CSA standards C22.1-94, Canadian Electrical Code, Part 1
and C22.2 No.0-M91 - latest edition** and all local codes and ordinances.
If codes permit and a separate ground wire is used, it is recommended that a qualified electrician
determine that the ground path is adequate.
Do not ground to a gas pipe.
Check with a qualified electrician if you are not sure the range hood is properly grounded.
Do not have a fuse in the neutral or ground circuit.
8
READ AND SAVE THESE INSTRUCTIONS
CAUTION
Tempest II Use, Care, and Installation Guide
P R O
T E M P E S T I I
U N D E R - C A B I N E T