Hitachi DH 40MC Instructions De Sécurité Et Mode D'emploi page 9

Selector lever
Fig. 7
NOTE
Turn the selector lever to check if it is completely
locked and make sure that it does not turn.
(2) When fixing working positions of tools such as cold
chisel, etc.,
(a) Turn the selector lever.
Align ▲ of the selector lever and
cover as illustrated in Fig. 8.
Selector lever
Fig. 8
(b) Turn the Grip or the Tool as illustrated in Fig. 9
and fix the tool to the desired working direction.
Tool Grip
Fig. 9
(c) Switch the selector lever to "hammering"
according to the procedures mentioned in the
above item (1) and secure the position of the tool.
5. Install the stopper (Fig. 10)
(1) Loosen the wing bolt, and insert the stopper into the
mounting hole on the side handle.
(2) Adjust the stopper position according to the depth of
the hole and tighten the wing bolt securely.
Stopper
6. Warming up (Fig. 11)
of the crank
The grease lubrication system in this unit may require
warming up in cold regions.
Position the end of the bit so makes contact with
the concrete, turn on the switch and perform the
warming up operation. Make sure that a hitting sound
is produced and then use the unit.
CAUTION
When the warming up operation is performed,
hold the side handle and the main body securely
with both hands to maintain a secure grip and be
careful not to twist your body by the jammed drill
bit.
7. How to use the drill bit (taper shank) and the taper
shank adaptor.
(1) Install drill bit with taper shank in the taper shank
adaptor. (Fig. 12)
English
Mounting hole
Wing bolt
Fig. 10
Fig. 11
9