Whirlpool AKZM 770 Manuel D'utilisation Et D'entretien page 29

AUTOMATIC OVEN CLEANING
For the description of this function, see the chapter CLEANING and the functions table at page 28.
To activate the oven's automatic cleaning cycle (pyro-cleaning), proceed as follows:
1. Turn the "Functions" knob to symbol
2. Press button to confirm your choice and start the pyro-cleaning cycle.
To select ECO pyro-cleaning, turn the "Browse" knob": the word ECO appears bottom right on the display. Press button
start the shorter programme.
During pyro-cleaning, the oven door is automatically locked and the symbol
at the end of the cleaning cycle: COOL" appears on the display, indicating the oven is still cooling down. When the oven cools
to a safe temperature, the symbol
N.B.: if the automatic door lock control procedure fails to execute properly, the symbol
other hand, the door remains closed due to a fault in the locking system,
case, contact the After-sales Service.
KEY-LOCK
This function can be used to lock the buttons and knobs on the control panel.
To activate it, press and
are locked and the display shows a key symbol. This function can also be activated during cooking. To deactivate it, repeat the
above procedure. When the key-lock function is activated, the oven can be switched off by turning the knob to 0 (zero). In this
case, however, the previously selected function will have to be set again.
: the word PYRO appears on the display.
switches off and the display shows "END".
at the same time for at least 3 seconds. When activated, the functions associated with the buttons
appears on the display. The door remains locked
and "DOOR LATCHED" appear on the display. In this
GB27
appears on the display . If, on the
to