Technical Specifications - Omnitronic DJP-1000 Mode D'emploi

Procedure:
Step 1: Unscrew the fuseholder on the rearpanel with a fitting screwdriver from the housing (anti-
clockwise).
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing and fix it.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.

TECHNICAL SPECIFICATIONS

Power Supply:
Power Consumption:
Power Output (RMS):
Stereo 4 Ohms
Bridged 8 Ohms
Frequency Response:
Signal-to-Noise Ratio:
Total Harmonic Distortion:
Input Connectors:
Output Connectors:
Protection:
Cooling:
Controls:
Indicators:
Construction:
Dimensions:
Weight:
Please note: Every information is subject to change without prior notice. 06.09.2006 ©
230 V AC, 50 Hz ~
1050 W
2 x 500 W
1 x 1000 W
10 Hz - 50 kHz
>102 dB
0.03 %
2 x XLR, 2 x Jack mounting socket
2 x pole terminal
Overheat, overload, short-circuit
2 radial fans
Power switch, input attenuators
Signal, Clip, Mode, Protect
Steel chassis, aluminium frontpanel
220 x 482 x 44 mm
4 kg
26/34 00015863.DOC VERSION 1.0