Table des Matières
Publicité
USER MANUAL LEDS220 011
Choose your location carefully. Do not install on surfaces which receive
foot or vehicle traffi c, near swimming pools or other areas of water, or
on trees/bushes that move in the wind. These may activate the motion
sensor and affect the operation of the light.
SUMMARY
YOU WILL NEED THE FOLLOWING TO INSTALL
THE LAMP:
Screwdriver
Goggles
Drill
Installation time: 45 minutes
Take care not to damage existing cables or pipes when drilling
the fi tting holes.
FITTING THE LAMP HEAD
1
Remove the back by turning it anticlockwise. (Fig. 1)
8
Stepladder
Soft cloth
Drill bit (5 mm)
2
3
You will need two rawlplugs to fi t the lamp on concrete or masonry.
Drill two 5-millimetre holes where the light is to be positioned, and
insert one rawlplug in each, fl ush with the surface. (Fig 2) Position the
back of the lamp so that the side with writing on it is visible, and fi x
with two wood screws. (Fig 3)
4
Fit the light by placing it at an angle to the back and turning it clock-
wise until it locks into place. (Fig 4).
FITTING THE SOLAR MODULE
The solar panel converts the sun's radiant energy into electricity. You
should therefore fi t the module in a place where it will get as much
direct sunlight as possible. Ideally, the solar panel should face south.
In central Europe, we recommend an angle of about 30° to 40°. Avoid
shade of any kind. Use the enclosed screws and rawlplugs to fi x the
module to a fi rm surface, such as masonry, and point it in the desired
direction.
Fit the cable of the solar cell to the lamp and connect the cable to the
light and the panel via a plug and socket. Use only the cable supplied,
do not shorten it, and avoid damaged during installation.
Publicité
Table des Matières
