Important Safety Information - Schwaiger LEDS220 011 Mode D'emploi

INTRODUCTION
Congratulations, and thank you for purchasing this solar LED lamp
and motion detector. All devices that we distribute comply with the
safety regulations valid at the time of purchase, and are safe provided
they are used for the intended purpose. Please observe the follow-
ing instructions to avoid possible hazards, damage and malfunctions.
These Operating and Safety Instructions are included with the solar
LED lamp and motion detector. They contain important information on
how to use the product. For simplicity, we have sometimes referred to
the entire product as „the lamp". Please read the instruction manual
carefully before using it. This particularly applies to the safety instruc-
tions. Failure to follow these can result in serious injury, or damage to
the lamp. This product is not a toy! Keep it out of the reach of children.
Retain the instructions for future reference. If you give the lamp to
someone else, make sure it is accompanied by these instructions.
HOW TO USE THIS LAMP
• The lamp is intended
• for use on an outdoor wall.
• It has an independent power supply in the form of a solar panel and
battery, and an infrared motion sensor.
It must not be used for any purpose other than
lighting.
Rear housing cover
Hardware Kit
(Actual hardware
may differ from
illustration.)
PLEASE NOTE:
Check that you have all the parts.
Solar unit
• Solar module and connector cable
• Solar module mounting plate
• Mounting screws for solar module (x2)
LED light
• Lamp head with battery status display and motion detector
• Swivel head with switches:
Light sensitivity (LUX)
Motion sensitivity (SENS)
Light-on time (TIME)
• 2 x 18650 Lithium-ion batteries 2200 mAh / 3.7 V
• Light mounting plate
• Mounting accessories (x2)
Check all parts for damage.
If solar module or LED light is damaged, do not use.
Please note before commissioning:
Recharge the batteries supplied before using the lamp for the fi rst
time. There are two options:
Charge the solar module with solar power
Connect the lamp to the solar module using the cable supplied. Set
the ON/OFF switch to OFF. Place the module in a location where it will
get as much direct sunlight as possible. Depending on the weather and
time of year, a full charge may take up to four days. Do not use the
lamp until it is fully charged.
Use a charger
Alternatively, use a suitable charger (not supplied) before using the
Light head
lamp for the fi rst time. Take the rechargeable batteries out of the
lamp and attach them to the charger. The charger must be suitable for
2,200=mAh/ 3.7 V 18650 lithium ion batteries.
Low battery
indicator
PLEASE NOTE:
LEDs may be damaged by electrostatic discharges. To prevent this from
happening while installing the lamp, ground yourself by touching an
earthed metal surface. To protect the light against damage, do not re-
move the transparent cover.

IMPORTANT SAFETY INFORMATION

1. Do not touch LEDs.
2. Do not remove transparent protective cover.
PIR Sensor
3. Never look directly into the light.
4. Electrical requirements: 2 x 18650 lithium-ion batteries
2200 mAh / 3.7 V
5. Must be fixed to a wall. Not suitable for ceilings or eaves.
USER MANUAL LEDS220 011
7