Compound Miter Cuts; Large Panel Cuts; Non-Through Cuts; Making A Non-Through Cut - ShopMaster DELTA S36-300 Guide D'utilisation

COMPOUND MITER CUTS

This is a combination of bevel crosscutting and mitering.
Refer to Fig. 26 and follow the instructions for both bevel
crosscutting and mitering. Remember to use the right
miter slot on the right side of the blade for all bevel cuts.

LARGE PANEL CUTS

Place workpiece supports at the same height as the
saw table behind saw to support the cut workpiece, and
alongside of saw, as needed. Depending on shape of
panel, use rip fence or miter gauge to control workpiece. If
a workpiece is too large to use either a rip fence or a miter
gauge, it is too large for this saw.

NON-THROUGH CUTS

The use of a non-through cut is essential to cutting
grooves, and rabbets. Non-through cuts can be made
using a standard blade having a diameter of 10 inches.
Non-through cuts are the only type of cuts that should
be made without the blade guard assembly installed.
Make sure the blade guard assembly is reinstalled upon
completion of this type of cut.
• When making non-through cuts, follow all applicable
warnings and instructions listed below in addition to
those listed above for the relevant through cut.
• When making a non-through cut, blade is covered by
workpiece during most of cut. Be alert to exposed blade
at start and finish of every cut.

MAKING A NON-THROUGH CUT

1. Unplug saw.
2. Unlock bevel lock.
3. Adjust bevel angle to 0°.
4. Lock bevel lock.
5. Remove blade guard and anti-kickback pawls.
6. Place riving knife in "lowered" position. (See RIVING
KNIFE ADJUSTMENT Section).
7. Set blade to correct depth for workpiece.
8. Depending on shape and size of wood, use either rip
fence or miter gauge.
MAKING CUTS
9
• Never feed wood with hands when making any non-
through cuts such as rabbets or grooves. Always
use miter gauge, push blocks or push sticks, and
featherboards where appropriate.
• In addition to this section, read the appropriate section
which describes the type of through or cut. For example,
if your non-through cut is a straight cross cut, read and
understand the section on straight cross cuts before
proceeding.
• Once all non-through cuts are completed, unplug saw
and return riving knife to through cut position. Install
anti-kickback pawls and blade guard.
• Carefully follow the instructions accompanying any
specialized blades for proper installation, set up and
operation.
9. Plug saw into power source and turn saw on.
10. Let blade build up to full speed before moving
workpiece into blade.
11. Always use push blocks, push sticks, and/or
featherboards when making non-through cuts to
reduce the risk of serious injury.
12. When cut is made, turn saw off. Wait for blade to
come to a complete stop before removing workpiece.
20
B
FIGURE 26
5