Charger Warnings - BERG E-Frame BFR Mode D'emploi

1.3 Charger warnings

• Do not use this charger for any other products. It is intended for Li-Ion battery powered vehicles
only.
• Do not connect the charger to the mains voltage when it is not used.
• Disconnect the charger from the battery before you start riding.
• Make sure that the charger does not get wet.
• Do not damage the charger.
• Do not operate the charger if it has been impacted, dropped, or damaged in any way. Examine the
charger and battery before each use and replace if wear or damage is found.
• The charger is designed to operate on standard household electrical power (200-240V or 110V using
the converter). Do not attempt to use the charger on any other voltage level!
• Never modify the electrical system as this may result in a risk of electric shock, electrocution or fire.
• To reduce risk of damage to the charger, pull from the plug rather than the cord when removing
from an outlet.
• Make sure the cord is located so that it will not be stepped on, tripped over, or otherwise subjected
to damage or stress.
• An extension cord should not be used unless absolutely necessary. Use of an improper extension
cord could result in the risk of fire, electric shock, or electrocution.
• To prevent electric shock, do not immerse the charger or battery in water when cleaning. To clean,
remove the charger/battery plug from the outlet and wipe with a dry cloth.
• Do not place any object on top of the charger or place the charger on a soft surface that may result
in excessive heat. Place the charger away from any heat sources.
• When charging is complete, disconnect the charger from the wall outlet and the battery. Place the
battery and charger in a place out of reach from children.
• Keep battery and charger in a dry place out of reach of children.
• Do not disassemble the charger or attempt to repair a damaged charger. If the charger is damaged
contact your BERG Dealer.
• This appliance is not intended for use by persons with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
10
E-Frame BFR