Scope Of Delivery - Clipster TaproX Mode D'emploi

3. Scope of delivery

1
Clipper
2
Comb (3 mm)
3
Comb (6 mm)
4
Comb (9 mm)
5
Comb (12 mm)
4. Operation, cleaning and care
Switching on and off:
Slide the On/Off switch back to turn the device on. Slide the On/Off switch forward again to turn the device off. (fig. 1)
This clipper can be used via its cable as well as without its cable.
Connect the power pack to the device socket located on the bottom of the device. Then connect the power pack to the power (fig. 2).
fig. 1
Cutting height adjustment:
The clippers have a 3-stage, cutting height adjustment.
Using the lever, you can adjust the cutting height between 0.5 - 1.0 mm (fig. 3).
Using the comb accessory:
1. Make sure that the On/Off switch is set to the 0 when installing and removing the comb. Four combs are available (3, 6, 9, and 12 mm) for
different cutting lengths. Push the comb onto the clipping head from the front, making sure that the comb engages on the bottom. (fig. 4)
2. Press the comb up as shown in fig. 5 to remove it. You can then replace the comb with another size by proceeding as described in 1.
fig. 4
Clean and oil the device on a regular basis to ensure the problem-free function and full functional performance of the clippers.
Cleaning the clipping head:
The clipping head should be thoroughly cleaned once a day with regular use.
Switch the device off. Disconnect the device from the power supply. Remove the comb attachment. Remove the hair with the cleaning brush.
Oiling the clipping head:
The clipping head must be oiled to ensure the good cutting results of the clipping head for as long as possible (during operation every 15 min.
and when stored, preferably on a daily basis). Remove the comb attachment. Use the brush to clean the cutting edge, removing the hair between
the blades. Oil the locations where the upper and lower part of the clipping head touch. The device must be oiled immediately when the shearing
performance diminishes noticeably or the temperature of the clipping head seems too high. The clipping head should be oiled once per day when
the clippers are not in use.
6
Protective cap
7
Cleaning brush
8
Oil
9
Power pack
5
3
1
fig. 2
fig. 5
13
6
4
7
8
2
9
fig. 3