Char-Broil 600 Série Guide D'utilisation page 10

5
Insert a small Hair Pin Clip into the hole at one end of the axle and bend the ends of the pin back so that it cannot be removed. Slide
a wheel onto the axle. Slide the axle through the holes at the ends of the short legs. Slide the remaining wheel onto the axle and
secure with the remaining Hair Pin Clip.
Finally, Push the wheel caps onto each end of the axle.
Hair Pin
Clip
6
Place the firebox onto the cart. The butterfly
damper should be on you right hand side.
Insert 4 each 1/4-20X1 3/4" screws through
cart and firebox. Secure the firebox using 4
each 1/4-20 flange nuts. Insert screws from
outside, flange nuts from inside chamber.
FULLY TIGHTEN ALL SCREWS AND NUTS
AT THIS TIME.
Page 10
Hair Pin Clip
1/4-20x1 3/4" Screw
Wheel Cap
1/4-20 Flange Nut