Temperature Indicator - Electrolux SC380FCN Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Temperature indicator

In order to help you better set your refrigerator, we have equipped it with a
temperature indicator located in the coldest area.
To better store the food in your refrigerator, especially in the coldest area, make
sure the message "OK" appears on the temperature indicator. If « OK » does
not appear, this means that the temperature setting has not been done properly.
Since "OK" appears in black, it will be difficult to see this indication if the
temperature indicator is badly lit. To be able to see this indication properly, there
should be enough light.
Each time the temperature setting device is changed, wait for the stabilisation of the
temperature inside the appliance before proceeding, if necessary, with a new temperature
setting. Please change the position of the temperature setting device progressively and wait
at least 12 hours before starting a new check and potential change.
NOTE: Following repeated openings (or prolonged opening) of the door or after putting fresh
food into the appliance, it is normal for the indication "OK" not to appear in the temperature
setting indicator. If there is an abnormal ice crystals build up (bottom wall of the appliance)
on the refrigerator compartment evaporator (overloaded appliance, high room temperature,
frequent door openings), put the temperature setting device on a lower position until
compressor off periods are obtained again.
Putting food in the coldest area of the refrigerator
Your foods will be better stored if you put them in the most appropriate
cooling area. The coldest area is just above the crisper.
The following symbol indicates the coldest area of your refrigerator.
To be sure to have a low temperature in this area, make sure the shelf is
located at the level of this symbol, as shown in the illustration.
The upper limit of the coldest area is
indicated by the lower side of the sticker
(head of the arrow). The coldest area upper
shelf must be at the same level with the
arrow head. The coldest area is below this
level.
As these shelves are removable, make
sure they are always at the same level with
these zone limits described on the stickers,
in order to guarantee temperatures in this
area.
Visual and text descriptions in the accessories section may vary according
to the model of your appliance.
EN -18-
OK

Publicité

Table des Matières
loading

Table des Matières