Programming Functions - Telcoma Automations SRC N Mode D'emploi

GB

PROGRAMMING FUNCTIONS

The transmitter can be programmed in such a way that it activates
the COSTA 2 ("EDGE2") output on the receiver. It is also possible to
cancel one or all of the transmitters from the receiver.
These functions are shown in the table below.
NUMBER
OF TIMES
1*
2*
3
4
10 sec**
* If the transmitter is already present in the receiver memory, the
buzzer will emit a repeated sound.
** Hold down button Pr1 for at least 10 seconds until the LED
remains illuminated steadily for a few seconds.
SETTING FREQUENCY
If a number of receivers are installed within a radius of 100 m, it is
advisable to set the receivers, and consequently the transmitters,
for operation on different frequencies.
To select the frequency, set dip-switches numbers 1 and 2 (2 in Fig.
2 and 1 in Fig. 5) according to tables TAB1 and TAB2.
32
RX LED
FLASHES
1
2
3
4
fixed light
FUNCTION
memorisation on COSTA1 ("EDGE 1")
memorisation on COSTA2 ("EDGE 2")
no function
cancellation of single transmitter
total cancellation of transmitters (RESET)