Troubleshooting - AEG HK854400FB Notice D'utilisation

30 www.aeg.com
Scratches or dark stains on the
glass-ceramic cause no effect on
how the appliance operates.
To remove the dirt:
1. – Remove immediately: melted
plastic, plastic foil, and food with
sugar. If not, the dirt can cause
damage to the appliance. Use a
special scraper for the glass . Put
the scraper on the glass surface at
an acute angle and move the
blade on the surface .

7. TROUBLESHOOTING

You cannot activate the
appliance or operate it.
An acoustic signal
sounds and the appli-
ance deactivates.
An acoustic signal
sounds when the appli-
ance is deactivated.
The appliance deacti-
vates.
The residual heat indica-
tor does not come on.
The Automatic Heat Up
function does not oper-
ate.
Problem
2.
3.
Possible cause
You touched 2 or more
sensor fields at the same
time.
The STOP+GO function
operates.
There is water or fat
stains on the control
panel.
You put something on
one or more sensor
fields.
You put something on
the sensor field
The cooking zone is not
hot because it operated
only for a short time.
The cooking zone is hot.
The highest heat setting
is set.
– Remove after the appliance is
sufficiently cool: limescale rings ,
water rings, fat stains, shiny metal-
lic discolorations. Use a special
cleaning agent for glass ceramic
or stainless steel.
Clean the appliance with a moist
cloth and some detergent.
At the end rub the appliance dry
with a clean cloth.
Remedy
Activate the appliance
again and set the heat
setting in less than 10
seconds.
Touch only one sensor
field.
Refer to the chapter
"Daily Use".
Clean the control panel.
Remove the object from
the sensor fields.
Remove the object from
the sensor field.
.
If the cooking zone oper-
ated sufficiently long to
be hot, speak to the
service centre.
Let the cooking zone be-
come sufficiently cool.
The highest heat setting
has the same power as
the Automatic Heat Up
function.