AEG HK854400FB Notice D'utilisation page 31

Problem
The heat setting changes
between two levels.
The sensor fields be-
come hot.
There is no signal when
you touch the panel sen-
sor fields.
comes on
comes on
comes on
and number comes
on.
Possible cause
The Power management
is activated.
The cookware is too
large or you put it too
near to the controls.
The signals are deactiva-
ted.
The Automatic Switch
Off operates.
The Child Safety Device
or the Lock function op-
erates.
There is no cookware on
the cooking zone.
The cookware is incor-
rect.
The diameter of the bot-
tom of the cookware is
too small for the cooking
zone.
The cookware does not
cover the cross / square.
There is an error in the
appliance.
ENGLISH
Remedy
Refer to "Power man-
agement".
Put large cookware on
the rear cooking zones if
necessary.
Activate the signals. Re-
fer to "OffSound con-
trol".
Deactivate the appliance
and activate it again.
Refer to the chapter
"Daily Use".
Put cookware on the
cooking zone.
Use the correct cook-
ware.
Use cookware with cor-
rect dimensions.
Cover the cross / square
fully.
Disconnect the appli-
ance from the electrical
supply for some time.
Disconnect the fuse from
the electrical system of
the house. Connect it
again. If comes on
again, speak to the serv-
ice centre.
31