KWC DOMO Instructions De Montage Et D'entretien page 22

EN
Installation
The product may only be installed by a
qualified plumber.
Observe the local installation regulations and
any country specific standards at all time.
Operating Data
Ideal operating pressure
Maximum operating pressure
Minimum operating pressure
Equal pressure is recommended
Ideal water temperature
Maximum water temperature
Environmental conditions
No cleaning agents or chemicals should be
stored in the immediate vicinity of faucets and
connection hoses.
Leaking vapors can damage the faucet and
connetion hoses.
Spare Parts
Only original spare parts may be used.
Flush Pipes
Flush the pipes according to the applicable stan-
dards before mounting the faucet.
10
General Cleaning Instructions
Faucet surface must be of room temperature be-
fore cleaning. Evaluated temperature increases
damage of the surface. Cleaning instructions of
the detergent manufacturer must be followed.
- Maintenance
Rub the faucet daily drey with a soft cloth.
3 bar
Never use corrosive cleaners or cleaning
5 bar
pads.
1 bar
- Cleaning
Dirt or calcium deposits on the faucet
60°C
surface must be removed with soft de-
70°C
tergent or with soap water. Rinse well with
water immediately after cleaning, until
all detergent is removed from the surface.
Dry with soft cloth.
12
Periodic Checks
For safety reasons, the connection and shower
hoses must be checked periodically for the
following:
- Watertightness
Damp or dripping hoses must be replaced.
- Corrosion
Hoses with rusty or oxidized surfaces must be
replaced.
- Mechanical damage
Hoses that show signs of mechanical damage
must be replaced.
KWC 802495-05 07/21