Husqvarna LGTH22V48 Manuel De L'opérateur page 10

The operation of any tractor can result in foreign objects thrown into the eyes, which can result
in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor
or per form ing any ad just ments or repairs. We rec om mend standard safety glasses or a wide
vision safety mask worn over spectacles.
HOW TO USE YOUR TRACTOR
TO SET PARKING BRAKE (See Fig. 4)
Your tractor is equipped with an operator presence sens-
ing switch. When engine is running, any attempt by the
op er a tor to leave the seat without first setting the parking
brake will shut off the engine.
• Depress clutch/brake pedal (B) all the way down and
hold.
• Pull parking brake lever (C) up and hold, re lease pres-
sure from clutch/brake pedal (B), then release parking
brake lever. Pedal should re main in brake position.
Ensure parking brake will hold tractor secure.
B
STOPPING (See Fig. 5)
MOWER BLADES -
• To stop mower blades, place attachment clutch control
in the "DIS EN GAGED" position (
( ) ATTACHMENT
CLUTCH SWITCH
"DIS EN GAGED"
GROUND DRIVE -
• To stop ground drive, depress clutch/brake pedal into
full "BRAKE" position.
• Move motion control lever to neutral position.
ENGINE -
• Move throttle control to slow po si tion.
NOTE: Failure to move throttle control to slow position and
allowing engine to idle before stopping may cause engine
to "back fire".
• Turn ignition key to "
Always remove key when leaving tractor to prevent
un author ized use.
• Never use the choke to stop the engine.
OPERATION
Fig. 4
).
( ) ATTACHMENT
CLUTCH SWITCH
"ENGAGED"
Fig. 5
" position and remove key.
STOP
IMPORTANT: LEAVING THE IGNITION SWITCH IN ANY
POSITION OTHER THAN "STOP" WILL CAUSE THE BATTERY
TO DISCHARGE AND GO DEAD.
NOTE: Under certain conditions when tractor is standing
idle with the engine running, hot en gine exhaust gases
may cause "browning" of grass. To eliminate this possibility,
always stop engine when stopping tractor on grass areas.
TO USE THROTTLE CONTROL (D) (See Fig. 6)
C
Always operate engine at full speed (fast).
• Operating engine at less than full speed (fast) reduces
the engine's operating efficiency.
• Full speed (fast) of fers the best mower per for mance.
TO MOVE FORWARD AND BACKWARD
(See Fig. 7)
The direction and speed of movement is controlled by the
motion control lever (J).
• Start tractor with motion control le ver in neutral position.
• Release parking brake.
• Slowly move motion control lever to desired position.
10
CAUTION: Always stop tractor com-
plete ly, as described above, before
leav ing the operator's position; to empty
grass catcher, etc.
D
Fig. 6
J
Fig. 7
F