Removing The Collected Water - mundoclima MH-V9 Série Manuel D'installation Et L'utilisauter

Wait 3 minutes before resuming the
operation. After the unit has stopped, it
cannot be restarted during the first 3
minutes. This is to protect the unit.
Operation will automatically start after 3
minutes.

Removing the collected water

There are two ways to remove collected water.
1. Use the tank
· When the tank is full, the unit will automatically
stop running, and the Full indicator light will flash.
· Slowly pull out the tank. Grip the left and right
handles securely and carefully pull out straight so
water does not spill. Do not put the tank on the
floor because the bottom of the tank is uneven.
Otherwise the tank will fall and cause the water to
spill.
· Throw away the water from the water outlet and
replace the tank. The tank must be in place and
securely seated for the dehumidifier to operate.
· The machine will re-start when the tank is restored in
its correct position.
Note:
· When you remove the tank, do not touch any parts
inside of the unit. Doing so may damage the product.
· Be sure to push the tank gently all the way into the
unit. Banging the tank against anything or failing to
push it in securely may cause the unit not to operate.
· When you remove the tank, if there is some water in
the unit you must dry it.
2. Continuous draining
Water can be automatically emptied into a floor
drain by attaching the unit with a water hose
()16.5*13.5 mm) (not included).
· Remove the rubber plug from the back of the unit
and store it in a safe location.
· Insert the water hose into
the unit from the drain
outlet in the back of the
unit.
· Attach the water hose to
the drain hose outlet of
the unit.
· Make sure the connection of the water hose and the
drain hose outlet of the unit is tight and do not let the
water leak.
· Then lead the water hose to the floor drain or a
Auto-Restart
If the unit stops unexpectedly due to a power cut, it will
automatically restart with the previous function
setting when the power resumes.
1. Pull out the tank a little.
2. Hold both sides of the tank with even strength,
and pull it out from the unit.
3. Pour the water out.
suitable drainage facility .The drainage facility
should be lower than the drain outlet of the unit. Be
sure to run the water hose sloping downward and
let the water to flow out smoothly. Do not install the
water hose.
R Remove the
r rubber plug
Insert the
water hose
from the
drain outlet
Do not block water flow with an inclination.
· Make sure the water hose is lower than the drain
hose outlet.
Note: When the continuous drain feature is not being
used, remove the drain hose from the outlet and
attach the rubber plug back to the drain outlet.
31
Water outlet
Do not block water flow with a hose twist.