Cleaning And Maintenance; Technical Specifications - Perel Tools EWL311 Mode D'emploi


Familiarise yourself with the functions of the device before actually using it.

All modifications of the device are forbidden for safety reasons. Damage caused by user modifications
to the device is not covered by the warranty.

Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, lamp explosion, crash, etc. Using the device in an unauthorised way will void the
warranty.

Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and
the dealer will not accept responsibility for any ensuing defects or problems.

Use the original packaging if the device is to be transported.

Keep this manual for future reference.
4. Features

die-cast aluminium housing with tempered glass

ribbed for maximum heat dissipation

sturdy stand with comfortable grip

suited for outdoor use (IP65).
5. Overview
Refer to the illustrations on page 2 of this manual.
1
power cord
2 hinge
3 protective glass
6. Installation
1. Keep at least 50 cm distance at the top and 30 cm on either side.
2. Respect a minimum distance of 1 m between the device's light output and any illuminated surface.
3. To point the lamp in the desired direction: loosen the hinges [2] using a spanner. Tilt the lamp in
the desired angle and tighten the hinges.
4. Connect the power cord to a suitable, earthed mains outlet.
7.

Cleaning and Maintenance


All screws should be tight and free of corrosion.

Mechanically moving parts must not show any signs of wear and tear.

The electric power supply cables must not show any damage. Have a qualified technician maintain
the device.

If the protective glass [3] is damaged, disconnect the lamp immediately from the mains. Have it
repaired immediately by a qualified technician. Do not use the lamp with a cracked or broken
protective glass.

Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.

There are no user-serviceable parts.

Contact your dealer for spare parts if necessary.
8.

Technical Specifications

All models
power supply
beam angle
cable
colour temperature
body colour
V. 01 – 02/12/2014
EWL311/EWL312/EWL313/EWL315
4
5
230 VAC
120°
H05RN-F 3G1.0, 1.5 m
6500 K
grey
4
LED
stand
©Velleman nv