Important Safety Instructions; Installation Instructions; Before Using Your Wine Chiller; Installation Of Your Wine Chiller - Avanti WC24T2P Manuel D'instruction

IMPORTANT SAFETY INSTRUCTIONS


WARNING
•
Read all instructions before using the Wine Chiller.
•
DANGER or WARNING: Risk of child entrapment.
Child entrapment and suffocation are not problems of the past. Junked or abandoned
appliances are still dangerous . . . even if they will "just sit in the garage a few days".
•
Before you throw away your old Wine Chiller: Take off the door. Leave the
shelves in place so that children may not easily climb inside.
•
Never allow children to operate, play with, or crawl inside the appliance.
•
Never clean appliance parts with flammable fluids. The fumes can create a fire
hazard or explosion.
•
Do not store or use gasoline or any other flammable vapors and liquids in the vicinity
of this or any other appliance. The fumes can create a fire hazard or explosion.
•
Do not repair or replace any part of the refrigerator or attempt any servicing unless
specifically recommended in the user-maintenance instructions or in published user-
repair instructions. Replace the fuse with the same type.
 Before Using Your Wine Chiller
•
Remove the exterior and interior packing.
•
Check to be sure you have all of the following parts:
•
6 Shelves
•
1 Instruction Manual
•
Clean the interior surface with lukewarm water using a soft cloth.
 Installation of Your Wine Chiller
 Place your wine chiller on a floor that is strong enough to support the unit when it is fully
loaded. To level your wine chiller, adjust the legs at the front of the unit.
 Allow 5 inch of space between the top and sides of the unit and a minimum of 4" at the
rear, which allows the proper air circulation to cool the compressor.
•
Locate the Wine Chiller away from direct sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the unit not to perform
properly.
•
Avoid locating the unit in moist areas.
•
Plug the Wine Chiller into an exclusive, properly installed-grounded wall outlet. Do not under
any circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized Avanti Products service center.
•
After plugging the Wine Chiller into a wall outlet, allow the unit to cool down for 2-3 hours
before placing any items in the compartment.
To reduce the risk of fire, electrical shock,

or injury when using your appliance, follow
these basic precautions:
-Save these instructions-

INSTALLATION INSTRUCTIONS

5