KitchenAid KUDP02FSPA Instructions D'installation page 14

11. Align the top edge of the customer-supplied custom panel
with the top of the console.
12. Drill two 3/32" pilot holes 1/2" (13 mm) deep, into the
customer-supplied custom panel, through the holes in the
top corners on the inner panel, as shown.
13. Install the two #8-18 x 1-3/8"
screws from the literature
package in the top corners
of the inner panel.
14. Tighten the six side screws reinstalled in Step 10.
Option 2: For models KUDI02FR, KUDP02FR, KUDS02FR,
KUDU02FR
All models require an accessory option to attach custom
panels. Kit No. 8212489 (black) or Kit No. 8212553 (stainless
steel) are available. To order, contact customer service at
800-444-1230.
NOTE: A customer-supplied full front custom panel must
weigh no more than 16 pounds (7.3 kg) and must be made
to specific dimensions. It is recommended that a
cabinetmaker cut the custom panel because of the precise
dimensions needed.
NOTE: All mounting hardware supplied is for a 3/4"
(19.1 mm) thick wood panel. If a thinner wood panel, or
materials other than wood are used, it is the consumer's
responsibility to obtain the proper length screws and adjust
the pilot holes accordingly.
IMPORTANT: Use a moisture resistant sealer on both sides
and all edges of the panel to protect it from humidity.
23-3/8" (59.4 cm)
custom panel dimensions
*This dimension is for 4" (10.2 cm) toe kick. If the installation needs a higher toe
kick, adjust the height of the wood panel accordingly. Not recommended for
toe kicks greater than 6" (15.2 cm).
14
inner panel
align top edges
drill through
these holes
1-3/8"screw
*30" (76.2 cm)
3/4" (19.1 mm)
1. With a T-15 TORX ® screwdriver, remove three screws from
both sides of door; save screws for reinstallation. Hold the
outer panel up while removing the screws.
2. Remove four screws from the latch area and top corners
of inner panel.
3 screws
outer panel
3. Partially close dishwasher door; tilt outer door panel
outward to lift up and remove. Gently set outer panel
aside.
4. Lay the cutomer-supplied custom panel face down on a
protective, non-scratching surface.
5. Measure 9-29/32" (25.2 cm) from top edge of customer-
supplied custom panel and mark a line on the back of
panel.
back
mark line
6. Position the outer panel on the back of the customer-
supplied custom panel as shown, so that the top holes in
the outer panel are on the line, and both panels are
centered side to side.
7. Mark all four hole locations; remove outer panel and drill
3/32" pilot holes 1/2" (13 mm) deep, in customer-supplied
custom panel.
8. Place the outer panel on the back of the customer-
supplied custom panel; align holes.
9. Attach outer panel to back of customer-supplied custom
panel with the four #10-16 x 3/8" hex head
screws supplied in the literature package.
3 screws
4 screws
9-29/32"
(25.2 cm)
top edge
mark pilot holes
hex head
screw