Roller Grill RFG 8 Mode D'emploi page 19

The heat release rate of the appliance is
The gas consumption is of :
RFG 8
The gas consumption is of :
RFG 12 B
For a use in natural gas, change the injectors of the burner, they are delivered in a
small plastic bag placed in the package.
To change the burner injector, unscrew the bottom part of the fryer. The pilot light
injector is accessible with a flathead screwdriver. To set it in natural gas, unscrew the
injector of a half turn.
Connect the appliance to the gas supply pipe, interposing a stop valve which enables
the appliance to be insulated from the rest of the installation.
Check the supply pressure using a manometer when all the burners are lit. It must be
equal to the indications on the rating plate.
This device must be installed with a sufficient ventilation to prevent the training of
concentrations of harmful substances.
The fresh air flow required for combustion air supply is:
- RFG 8 8.15m3/h
- RFG 12 B 16.3m3/h
General conditions of installation
We remind you that it is recommended to call on an qualified installer qualified to set
up this appliance and if necessary to adapt it for the natural gas using.
Parts sealed in factory must not be handled neither by the installer nor the user.
The installation and maintenance of the appliance must be carried out in compliance
with the statutory texts and good practices in force, mainly:
General specifications
For all appliances:
Article GZ Installation with combustible gases and liquefied hydrocarbons.
RFG 8 4 kW with G30/G31
4 kW with G20/G25
RFG 12 B 8 kW with G30/G31
8 kW with G20/G25
846 l/h with G20 and 983 l/h with G25
630 g/h with G30 and 621 g/h with G31
846 l/h with G20 and 983 l/h with G25
630 g/h with G30 and 621 g/h with G31
19