Lamp Replacement - Cata ControlAir C1-T600 Instructions Pour L'installation, L'utilisation, L'entretien

EN

Lamp replacement

Warning: do not handle the bulbs until the electricity supply has been switched off and
they have cooled.
Important: use new bulbs according to that indicated on the hood nameplate.
If using LED lighting, do not look directly at the light.
Use bulbs with an aluminium reflector to replace halogen bulbs. Do not use dichroic bulbs - risk
of overheating.
For LED lamp replacements, please contact Technical Support or the distributor of the brand.
Problem
The lamps do not work
The motor works, but it seems to
have requested performance or ex-
traction capacity
The hood works, but the smell of the
food persists.
The hood does not work
The hood still does not work
24
Cause / Solution
A change may be necessary, but first check that the
lamp is correctly positioned and that the contact is
correct. Remember that lamps are not covered by the
warranty. Disconnect the current hood before hand-
ling the lamps. Use lamps with the same properties
described on the nameplate.
It is advisable to use lamps supplied by the manufac-
turer of the hood.
The selected speed is too low / Select a higher speed.
Check the Metallic Filter (grease filter). If it has not
been washed recently, it may be clogged with grea-
se or dirt. Disassemble and wash it in hot water and
detergent, and let it dry before reassembling again.
Ensure that the air outlet tube has not been obstruc-
ted.
If you are using the hood in recirculation mode, the
Active Carbon Filter must be replaced.
Check that the hood is connected to power. Check
that the fuses or automatic have not jumped.
If, after having checked the points mentioned above,
your problem has not yet been solved, contact the
technical service or your distributor.
FAQS