Waring Commercial MX Série Mode D'emploi page 7

8. Allow motor to come to a complete stop before removing container from
blender base. Never place the container on the motor base or remove it
from the motor base while motor is running.
9. Wash and dry container after each use. See Cleaning and Sanitizing
Instructions.
10. To turn the unit off, press STANDBY
go off.
Warning – This is a class a product. in a domestic environment this
product may cause radio interference in which case the user may be
required to take adequate measures.
1. Before starting, make sure that the blender
is unplugged.
2. With the unit in STANDBY position, place
container on blender base. Be sure
container is fully seated and that drive
coupling is properly engaged. Plug blender
cord into outlet.
3. Put ingredients into container and cover it.
Do not fill above MAX line.
4. This blender has variable speed controls.
Set blender to desired speed between 1 and 10.
5. The left paddle switch defaults to the VARIABLE setting in order to use
the speed adjustment option. Press right paddle switch up to the ON
position.
6. When finished blending, set paddle switch to STANDBY position.
7. This blender is equipped with a pulse option. Hold left paddle switch
in down position to engage pulse function. Unit will run on max speed
(30,000 RPM's) until the paddle switch is released.
8. Allow motor to come to a complete stop before removing container
from blender base. Never place the container on the motor base or
remove it from the motor base while motor is running.
9. Always hold container with one hand when starting and while blending.
Never operate without jar lid.
10. Wash and dry container after each use. See Cleaning and Sanitizing
Instructions, pages 7-8.
To minimize the possibility of being scalded when blending hot materials,
the following precautions and procedure must be observed.
• Hot materials are those which are 38°C or hotter
• Limit the amount of materials processed to 0.5 liters
• Completely remove the center portion of the two-piece container lid
before starting motor (This will allow venting of the rapidly heated and
expanding air inside the container when blender is running.)
• Always start blending on lowest speed setting, and then progress to
desired speed.
• Never stand directly over blender when it is being started or while it
is running.
mX VariaBle SPeeD oPeraTion
imPorTanT HoT BlenDing inSTrUcTionS
button. Green LED light will
7