Waring Commercial MX Série Mode D'emploi page 4

1. Before starting, make sure that the blender
is unplugged.
2. With the unit in "STANDBY"
container on blender base. Be sure container is fully
seated and that drive coupling is properly engaged.
Plug blender cord into outlet.
3. Put ingredients into container and cover it. Do not
fill above MAX line.
4. This blender has 2 speed settings: HI
to desired position. To crush ice quickly, use HI
5. When finished blending, set paddle switch to "STANDBY"
6. This blender is equipped with a PULSE
down to engage PULSE
the paddle switch is released.
7. Allow motor to come to a complete stop before removing container
from blender base. Never place the container on the motor base or
remove it from the motor base while motor is running.
8. Always hold container with one hand when starting and while blending.
Never operate without jar lid.
9. Wash and dry container after each use. See Cleaning and Sanitizing
instructions.
NOTE: If you have an electronic unit, please refer to the following
instructions.
1. Before starting, make sure that the blender is
unplugged.
2. Place container on blender base. Be sure container
is fully seated and that drive coupling is properly
engaged. Plug blender cord into outlet.
3. Put ingredients into container and cover it. Do not
fill above MAX line.
4. This blender is equipped with an electronic
membrane keypad. The keypad has a main power STANDBY
and HI and LO , STOP
5. Press the STANDBY
illuminate. For continuous operation, press either LO or HI
When finished blending, press STOP
press the PULSE
button is released.
noTe: Your MX Electronic Blender utilizes a Slow Start
pressing HI
then switch to HI
ingredients in container.
mX mecHanical SWiTcHeS
mX elecTronic ToUcH PaD SWiTcHeS
WiTHoUT SoUnD encloSUre
button to turn on the blender. Green LED will
button; motor will run on HI
, the unit will start in the "Low" speed for 2 seconds and
speed. This allows for a more even blending of
position, place
and LO . Press Paddle Switch
function. Unit will run on HI
and PULSE
. For momentary operation,
4
speed setting.
option. Hold paddle switch
speed until
buttons.
speed until the
feature. When
™
position.
button,
button.