Features; Assembly - Ryobi P213 Manuel D'utilisation

PRODUCT SPECIFICATIONS
No Load Speed .......................0-400/0-1,500 r/min. (RPM)
Clutch.................................................................24 position
UNPACKING
This product requires assembly.
 Carefully remove the tool and any accessories from the
box. All items listed in the Includes section must be
included at the time of purchase.
WARNING:
Items in this Assembly section are not assembled to
the product by the manufacturer and require customer
installation. Use of a product that may have been
improperly assembled could result in serious personal
injury.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance. In Mexico, please call
01-800-843-1111.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.

FEATURES

Torque ................................................................... 330 in.lb.
Hammer Speed (Blows per minute)
................................................... 0-5,200/0-19,500 BPM

ASSEMBLY

INSTALLING/ADJUSTING THE AUXILIARY
HANDLE ASSEMBLY
See Figure 1, page 10.
An auxiliary handle is packed with the drill for ease of opera-
tion and to help prevent loss of control. The handle can be
mounted for left or right hand use.
 Insert the handle screw into the hole located above the
trigger switch and seat the hex head into the hole.
 Slide the handle collar onto the screw. Seat the hex end
of the collar into the hex hole.
NOTE: Be sure the hex hole for the depth stop rod sits
on top of the collar.
 Slide the depth stop rod into the hex-shaped hole on top
of the collar.
 Slide the depth stop rod clamp into the notch in the collar.
The clamp holds the depth rod firmly in place.
NOTE: When properly installed, the teeth on the depth stop
rod should be aligned with the teeth indicator on the depth
stop rod clamp.
 Thread the auxiliary handle onto the screw and secure
tightly.
NOTE: Be sure the the auxiliary handle is securely tightened
against the depth stop rod clamp. This secures the depth
stop rod at the desired depth of cut. It also secures the
auxiliary handle.
5 — English