Water Drainage; Manual Drainage - Ayce JHS-A0012 Manuel D'utilisation

1. When the machine is powered on for the first time, the buzzer will make a
sound "di", and then the machine will get into standby status.
2. POWER
Press this key to turn on / off machine.
3. MODE
After machine turns on, press this key to select cooling, fan and dehumidifying
mode.
4. TEMPERATURE / TIME ADJUSTING "UP" and "DOWN"
Press these two keys to change the set temperature or timing setting value.
While setting temperature, press "UP" or "DOWN" to select the necessary
temperature (not available in fan and dehumidifying mode).
While setting timing value, press "UP" or "DOWN" to select the required timing
value
Simultaneously press both keys to switch between Celsius (°C) and Fahrenheit
(°F).
5. FAN SPEED
After machine turns on, press this key to select fan speed (High / Mid / low),
and can be adjust to the fan speed only under "cool" and "fan" mode.
TIMER
6.
When pressing "TIMER" button, the user can be setup the switch ON or OFF
time once the indicate light of "TIMER" lights up.
Under standby state, press "UP" or "DOWN" to setup the time to switch on
from "1hour to 24 hours".
Under power-on state, press "UP" or "DOWN" to setup the time to switch off
from "1hour to 24 hours".
7. SWING
Press this key at any time after turning on the machine to swing the Swing
louver automatically.
Note:
1) The Swing louver will automatically turn on once switch on the appliance.
2) The Swing louver will automatically turn off once switch off the appliance.
3) Can only use the remote control to set the swing direction, cannot set on
the LCD Type Soft - Touch Control Panel.
SLEEP
8.
In the cooling mode, press "UP" and "Fan" on control panel or press the button
" " on remote control to turn on the sleep mode, then the unit will work on
Energy-Saving and quiet type.
Note: Cannot select the sleep mode in the dehumidifying or Fan mode.

WATER DRAINAGE

Manual drainage

1. When the machine stops after the water tank is full, turn off the machine
power and unplug the power plug.
Notes: Please move the machine carefully, so as not to spill the water in the
water pan at the bottom of the body.
2. Place the water container below the side water outlet behind the body.
3. Unscrew the drainage cover and unplug the drainage plug, the water will
automatically flow into the water container.
Notes:
1) Keep the drainage cover and the drainage plug properly.
2) During drainage, the body can be tilted slightly backwards.
3) If the water container cannot hold all the water, before the water container
is full, stuff the water outlet with the drainage plug as soon as possible to
prevent water from flowing to the floor or the carpet.
4. When the water is discharged, stuff the drainage plug, and tighten the drainage
cover. (as shown in Fig.7)
Note: Restart the machine after the drainage plug and drainage cover are
installed, otherwise condensate water of the machine will flow to the floor or
the carpet.
Continuous drainage (as shown in Fig 8)
Note: Only applicable to cooling and dehumidifying mode.
Unscrew the drainage cover, and unplug the drainage plug.
1.
2. Set the drainage pipe (not include) into the water outlet.
3. Connect the drainage pipe to the bucket.
78 | 79 GB
Fig.7