Operating The Appliance - VINCENT STU-3 Manuel D'utilisation

Operation
Switch on and off
Select the frequency
band
Switch between
stereo/mono
Select a radio frequency
in manual search mode
Select a radio frequency
in Autoscan mode
Vincent
32

OPERATING THE APPLIANCE

Button(s) Description
The appliance does not have a standby switch, it is switched on and off at the
front. When switched off it is disconnected from the power supply. Before swit-
POWER (1)
ching on, the volume setting on the amplifier/preamplifier/receiver should, as
a precaution, be reduced.
This button is found on both the remote control and the front of the appli-
ance. This allows you to switch between the FM (VHF) and AM (MW)
AM/FM
modes when the radio is on. VHF offers better sound quality and a greater
(7)(19)
selection of stations. The display shows you the abbreviation "AM" or
"FM", depending on the frequency band setting you have chosen.
This button is found on both the remote control and the front of the appliance.
If a station can only be received with poor quality in stereo, there is an option
ST/MONO
of listening to it in mono mode. This can improve the sound quality. Switching
(4)(23)
between these two is only possible for FM stations. Whilst this setting is active,
the display shows "MONO" in small letters.
Use the "TUNING MODE" button on the front of the appliance or on the
TUNING remote control to select from the three possible settings (function of the but-
MODE tons "TUNING PRESET") the option "MANUAL". As long as this mode is
(3)(20) selected you can change the radio frequency up or down in steps of 0.05
MHz for FM and 9 kHz for AM, using the buttons "TUNING PRESET". If you
TUNING have found a station with a strong enough signal, this is signalled by the
PRESET abbreviation "TUN" in the display. If "ST" is displayed, the station can be
UP/DOWN played back in stereo. If "RDS" is displayed, the station offers RDS services.
(9)(24) As long as the manual scan mode is selected, the text "AUTO" does not
appear in the display. If "RDS" is displayed, the station offers RDS services.
Use the "TUNING MODE" button on the front of the appliance or on the
remote control to select from the three possible settings (function of the but-
tons "TUNING PRESET") the option "AUTOSCAN". As long as this mode is
TUNING
selected the display shows the text "AUTO". Now the buttons "TUNING
MODE
PRESET" make the tuner step through all frequency settings automatically if
(3)(20)
touched once. The automatic search stops when the tuner has found a fre-
quency at which a radio station can be received. If the tuner has found a
TUNING
station with a strong enough signal, this is signalled by the abbreviation
PRESET
"TUN" in the display. If "ST" is displayed, the station can be played back in
UP/DOWN
Stereo. The scan process can be stopped by one more actuation of "UP" or
(9)(24)
"DOWN". If "RDS" is displayed, the station offers RDS services. The scan
process can be stopped by one more actuation of "UP" or "DOWN". If
"RDS" is displayed, the station offers RDS services.