Operating The Appliance - VINCENT STU-2 Manuel D'utilisation

Operation
Switch on and off
Select the frequency
band
Switch between
stereo/mono
Select a radio frequency
in manual search mode
Select a radio frequency
in Autoscan mode
Vincent
32

OPERATING THE APPLIANCE

Button(s) Description
The appliance does not have a standby switch, it is switched on and off at the
front. When switched off it is disconnected from the power supply. Before swit-
ching on, the volume setting on the amplifier/preamplifier/receiver should, as
POWER (4) a precaution, be reduced. After switching on, the device takes 30 seconds to
warm up the tubes of the amplifier circuit. During this time, the LED "WARM
UP" (5) flashes and the message "WAITING" appears on the display. In swit-
ched-on mode, the LED "WARM UP" is permanently lit.
This button is found on both the remote control and the front of the appli-
ance. This allows you to switch between the FM (VHF) and AM (MW)
AM/FM
modes when the radio is on. VHF offers better sound quality and a greater
(9)(22)
selection of stations. The display shows you the abbreviation "AM" or
"FM", depending on the frequency band setting you have chosen.
This button is found on both the remote control and the front of the appliance.
If a station can only be received with poor quality in stereo, there is an option
ST/MONO
of listening to it in mono mode. This can improve the sound quality. Switching
(8)(26)
between these two is only possible for FM stations. Whilst this setting is active,
the display shows "MONO" in small letters.
Use the "TUNING MODE" button on the front of the appliance or on the
remote control to select from the three possible settings (function of the but-
TUNING tons "TUNING PRESET") the option "MANUAL". As long as this mode is
MODE selected you can change the radio frequency up or down in steps of 0.05
(7)(23)
MHz for FM and 9 kHz for AM, using the buttons "TUNING PRESET". If
you have found a station with a strong enough signal, this is signalled by
TUNING the abbreviation "TUN" in the display. If "ST" is displayed, the station can
PRESET
be played back in stereo. If "RDS" is displayed, the station offers RDS ser-
UP/DOWN vices. As long as the manual scan mode is selected, the text "AUTO" does
(11)(27) not appear in the display. If "RDS" is displayed, the station offers RDS ser-
vices. As long as the manual scan mode is selected, the text "AUTO" does
not appear in the display.
Use the "TUNING MODE" button on the front of the appliance or on the
remote control to select from the three possible settings (function of the but-
tons "TUNING PRESET") the option "AUTOSCAN". As long as this mode is
TUNING
selected the display shows the text "AUTO". Now the buttons "TUNING
MODE
PRESET" make the tuner step through all frequency settings automatically if
(7)(23)
touched once. The automatic search stops when the tuner has found a fre-
quency at which a radio station can be received. If the tuner has found a
TUNING
station with a strong enough signal, this is signalled by the abbreviation
PRESET
"TUN" in the display. If "ST" is displayed, the station can be played back in
UP/DOWN
Stereo. The scan process can be stopped by an actuation of one of the but-
(11)(27)
tons "TUNING PRESET". If "RDS" is displayed, the station offers RDS ser-
vices. The scan process can be stopped by one more actuation of "UP" or
"DOWN". If "RDS" is displayed, the station offers RDS services.