VINCENT STU-3 Manuel D'utilisation page 25

1 2 3
1. POWER
This is the main power switch for turning on and
off the device. The tuner is separated from the
mains voltage when switched off and cannot be
set into a standby state.
2. RDS MODE
With this button the various RDS services can be
displayed on the front panel or the RDS system
can be switched off.
3. TUNING MODE
With this button you determine the functionality of
"TUNING PRESET": make them do a manual fre-
quency scan, an automatic search run or switch
between saved stations.
4. ST/MONO
With this, one can switch over between stereo
and mono reception in the operating mode "FM".
It is an important option for receiving FM stations
with weak signals.
5. Display
In normal operation shows either the name of the
selected input channel or frequency and RDS
information of the radio stationed it is tuned to. In
tuner mode additional information about the ope-
ration mode is shown.
FRONT VIEW
5
4 7
6. Number keys
Using these buttons you can input a station fre-
quency or a preset number.
7. AM/FM
This button helps in switching over between recei-
ving FM stations and medium wave stations (AM).
8. MEMORY
This button is required for saving a radio frequen-
cy to one of the station presets.
9. TUNING PRESET
With these buttons, a search run through the fre-
quency band can be initiated (automatic, manual
or through all station memory).
10. DIRECT: numerical frequency input
After pressing this button, a transmitter frequency
can be entered by using the number buttons
(6)(21), which the tuner then sets up.
6
8 9 10
:
Vincent
25