VINCENT STU-3 Manuel D'utilisation page 37

Symptom
No RDS
Poor sound quality
The remote control
cannot perform any
functions
Humming low fre-
quency noise is
audible, even as
no audio source
is playing back
SEARCH FOR ERRORS
Possible Cause
An AM station has been selected, only FM
stations support RDS.
The FM station does not support RDS.
RDS function is switched off.
The cable connections are not tight, the con-
nectors are dirty or a cable is defective.
No batteries inserted in the remote control,
batteries are not inserted correctly or are
depleted.
The line-of-sight between the remote control
and the unit is obstructed, the range was
exceeded or the hand unit was operated
from a position too far to one side.
The unit is not switched on.
See section "Net frequency noise" in the
chapter "Tips".
Countermeasure
Live without this service or tune to another FM
station.
Live without this service or tune to another FM
station.
Switch on the function with the button "RDS
MODE" (2)(25).
Check the cables and cable connections.
Check and replace the batteries if necessary.
Try to point the remote control at the front of
the unit only when the sight-line is clear, wit-
hin a 7-metre distance and, if possible,
facing the unit.
Switch on the unit.
See section "Net frequency noise" in the
chapter "Tips".
Vincent
37