Dispensing Cappuccino / Milk Coffee; Dispensing Milk; Programming The Amount Of Milk In A Cup - Caffitaly System S22 Mode D'emploi

Dispensing cappuccino / milk coffee

• Fill the jug with the desired amount of milk.
• Make sure the milk jug knob is in the dispensing position (Fig. 10).
• Fit the milk dispenser fi rst and then the jug in its special place (Fig. 5). Buttons D-E-F blink.
Wait until they light up steady.
• Raise the lever to open the capsule compartment (Fig. 1).
• Insert the capsule, pressing it gently inside (Fig. 2).
• Close the lever fully (Fig. 3).
• Place a cup under the coffee and milk dispenser (Fig. 8).
• Press (briefl y) button D or E, depending on the desired beverage with milk.
• The pressed button will blink. The machine dispenses the programmed amount of milk. The
coffee is then automatically dispensed.
• Dispensing stops if the button selected during the cycle is pressed.
• Raise the lever to eject the used capsule into the drawer (Fig. 1).
• Close the lever (Fig. 3).
NB: For better results, use milk at temperature approx. 4°-8°C. • If the milk jug is
removed and put in the fridge, it is advisable not to keep the milk for more than two
days. Do the "Milk jug cleaning cycle" (see the relevant section) after every dispensing
of a beverage with milk.
• Fill the jug with the desired amount of milk.
• Make sure the milk jug knob is in the dispensing position (Fig. 10).
• Fit the milk dispenser fi rst and then the jug in its special place (Fig. 5). Buttons D-E-F blink.
Wait until they light up steady.
• Place a cup under the milk dispenser (Fig. 8).
• Press button F.
• The pressed button will blink. Dispensing stops when the programmed amount is reached.
NB: For better results, use milk at temperature approx. 4°-8°C. If the jug is removed
and put in the fridge, it is advisable not to keep the milk for more than two days. Do the
"Milk jug cleaning cycle" (see the relevant section) after every dispensing of a beverage
with milk.

Programming the amount of milk in a cup

• Fill the jug with the desired amount of milk.
• Make sure the milk jug knob is in the dispensing position (Fig. 10).
• Fit the milk dispenser fi rst and then the jug in its special place (Fig. 5). Buttons D-E-F blink.
Wait until they light up steady.
• Place a cup under the milk dispenser (Fig. 8).
• Press and hold down button D, E or F, depending on the desired beverage with milk.
• On reaching the desired amount of milk, release the button. The button is now programmed.
• If button D or E is pressed, the machine will automatically dispense the coffee once released.
English

Dispensing milk

43