Hansgrohe Raindance Select S 240 2jet Showerpipe 27129 1 Série Instructions De Montage / Mode D'emploi / Garantie page 2

English
Technical Information
Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Flow rate (max.)
showerhead
handshower
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
Inspect the showerpipe for shipping damage
before installation. Claims for shipping
damage made after the showerpipe is
installed will not be honored.
• For best results, Hansgrohe recommends installation
by a licensed, professional plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all the tools and supplies needed to complete
the installation.
• This showerpipe requires showerpipe rough
16181181(not included).
• Protection against backflow is provided by check
valves.
• Do not install this showerpipe in a steam shower.
• Make sure that the wall is strong enough to support
the showerpipe. The wall must be reinforced at the
mounting points. The area where the top mounting
piece is to be installed must be flat and free of
protruding grout joints, etc.
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*
2.5 GPM (9.5 L/min)
2.5 GPM (9.5 L/min)
• The enclosed screws and anchors are suitable for
a solid surface wall. For other wall constructions,
the installer should select mounting hardware and
reinforcement suitable for that specific construction.
• This showerpipe is for use with shower heads rated
at 1.5 GPM (5.7 L/min) or higher.
• To prevent scald injury, the maximum output
temperature of the shower valve must be no
higher than 120°F (49°C). In Massachusetts, the
maximum output temperature can be no higher than
112°F (44°C).
This showerpipe must not be used as a grab
bar. If a grab bar is required, install one
separately.
The shower arm is intended to hold the
showerhead only. Do not use it to hold other
objects.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.